RE: [Xen-users] No eth0 in domU...

["Kraska, Joe A \(US SSA\)" <joe.kraska@xxxxxxxxxxxxxx>]

Ran across this problem recently. Below attached worked for me on a
reboot. Still gathering "low level linux administration expertise"
here. Would one alternative to the modprobe.conf be to recompile the
domU kernel such that it needs no such modprobe entry?
---------------------------------------------------------------------

The problem here is that you need to add the following to your
modprobe.conf of your domU:

alias eth0 xennet
---------------------------------------------------------------------
Above works fine. I don't seen an obvious way to compile xennet support
into the kernel wholesale. Is there a way?

Joe.


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users