[Xen-users] can't get multiple VLANs to work

[Tomasz Chmielewski <mangoo@xxxxxxxx>]

I'm trying to set up Xen 3.0.2 to serve multiple guest domains, each 
using a unique VLAN.
I start xend with a simple script that executes network-bridge for 
several domains with different VLANs:
dir=$(dirname "$0")

"$dir/network-bridge" "$@" vifnum=0 netdev=eth0.140 bridge=xenbr140

"$dir/network-bridge" "$@" vifnum=1 netdev=eth0.160 bridge=xenbr160


However, it doesn't seem to work - only one guest has network connectivity.

When I run tcpdump on dom0, I see that some packets are getting through 
from domU which has problems with network access, but that's about it.
How should I start multiple guest domains to use different VLANs? I 
searched the mailing list, and found some references to "vif-vlan" 
scripts etc., but didn't find anything that would solve my problem.
Is there anyone out there using Xen with a couple of domains, which use 
different VLANs? I would be thankful for any suggestions on where the 
problem might be (and no, it's not checksumming).
--
Tomasz Chmielewski
http://wpkg.org



_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users