Re: [Xen-users] Host uses one NIC; Guest OS uses other NIC

[Igor Chubin <igor@xxxxxxx>]

On Mo, Mär 31, 2008 at 12:49:33 -0400, James Pifer wrote:
> I'm trying to setup my first Xen server that will host two Virtual
> Servers. I have the first guest OS installed, but I cannot get it to
> connect to the network. 


Please, show the output of

# brctl show

run in dom0

and provide more info about procedure you use
to test network connectivity.



> 
> Here's the info. 
> xen version is 3.0.4_13138-0.40
> host server has two NICs
> eth0 is associated to peth0
> eth0 does NOT have an IP address assigned on the host server
> host server uses eth1 and has an ip address assigned
> 
> So the host server works fine on eth1. I can also assign an address to
> eth0 and the host server can use it. BUT, I really don't want the host
> OS to use the network on eth0, ONLY the guest OSes. I assume this can be
> done, but maybe I'm mistaken. eth0 and eth1 will be on different
> subnets. Host server should use eth1 while guests use eth0.
> 
> My guest OS does not communicate with the network on peth0 at all. I've
> been looking at the wiki (http://wiki.xensource.com/xenwiki/HowTos) but
> can't figure it out. 
> 
> Anyone have any suggestions?
> 
> Thanks,
> James
> 
> 
> 
> 
> _______________________________________________
> Xen-users mailing list
> Xen-users@xxxxxxxxxxxxxxxxxxx
> http://lists.xensource.com/xen-users

-- 
WBR, i.m.chubin


_______________________________________________
Xen-users mailing list
Xen-users@xxxxxxxxxxxxxxxxxxx
http://lists.xensource.com/xen-users